Ultrasonic Frequency – 25kHz vs. 40kHz

Recently, there has been a lot of attention directed at the new and expanding range of ultrasonic frequencies available in advanced design ultrasonic cleaning equipment. The result has been that there has been a de-emphasis on the “workhorse” frequencies that started it all, 25 and 40kHz.  The fact is that the vast majority of industrial ultrasonic cleaning applications still use these relatively low ultrasonic frequencies.  This blog will take a quick look at the relative merits of each.

There are several references that talk about the effect of frequency on things like cavitation bubble size, cavitation intensity, the number of cavitation bubbles, and other things like the “barrier layer.”  Just click on the “search” box at the bottom of this and type in “frequency” for what I’ve said in the past about frequency.  More in-depth references can be accessed using the following links –

Introduction to Ultrasonic Technology

Fundamentals of Ultrasonics

Designer Waveforms

The above serve as guides to the selection of the proper ultrasonic frequency for a particular application but may be a little “long-winded” for those looking for answers regarding just 25 and 40kHz.  So let me summarize.

First off, the difference between the cleaning performance of frequencies in this lower frequency range is usually not seen as quantum changes but, rather, in subtle differences in cleaning.  Lower frequency produces larger cavitation bubbles which results in each implosion of a cavitation bubble having a higher energy level.  As frequency is increased, the size of the cavitation bubbles becomes smaller which means that each bubble implosion will have relatively less energy.  The difference in energy levels is compensated for by the fact that more cavitation bubbles are produced as the frequency is increased.  This relationship is described in more detail in the blog

Ultrasonics – Number and Size of Cavitation Bubbles

A lower frequency ultrasonic cleaner, then, provides more aggressive cleaning than a higher frequency unit with an equivalent power output.  But, there are some not-so-beneficial consequences of using lower frequency as well.

Because of the higher energy implosion of cavitation bubbles at a lower frequency there is a risk of causing physical damage to the parts being cleaned.  More specifically, softer metals such as aluminum and brass, may show “cavitation burning” as minute particles of the substrate are physically removed from the surface.  Lower frequency equipment also tends to create more audible sound as the operating frequency is only slightly above the range of human hearing.

Higher ultrasonic cleaning is more gentle in nature and less likely to create “cavitation burning” of the parts being cleaned.  Higher frequency also results in less audible sound being produced by the ultrasonic cleaning equipment.

As I said earlier, don’t expect to see any quantum change in cleaning resulting from a change in frequency in this frequency range.  Twenty five and 40kHz frequencies are, as I said earlier, “workhorse” frequencies usually intended to remove gross contaminants from relatively robust parts.  The fine points of frequency selection described in some of the references above come into play only when one is cleaning delicate parts or when the -removal of micron or sub-micron sized particles is the primary concern.

In conclusion, in my 40+ years of experience in ultrasonic cleaning, I can count on my fingers the number of applications that could be accomplished using 25 or 40kHz which could absolutely not be accomplished using the other by adjusting the parameters of time, temperature and chemistry.

Leave a Reply